BODY ± Fuel Filler Door
42-7
REMOVAL SERVICE POINT
AA" RIVET REMOVAL
Use a drill (é4.0 ± 5.5 mm) to break the rivet by drilling a
hole, and then remove the rivet.
INSTALLATION SERVICE POINT
" AA RIVET INSTALLATION
Use a riveter shown to install rivets as follows:
1. Insert a rivet in the body panel and fuel filler door panel
assembly.
2. Insert the riveter to the rod (A shown) of a rivet.
3. Pressing the flange surface of the rivet with the riveter,
handle the riveter.
4. The rod is cut at its thinnest point and the rivet is held
in position.
Drill
Fuel filler
door panel
assembly
Rivet
Riveter
Fuel filler door
panel assembly
Body
panel
Rivet
Riveter
Flange surface
Rivet
A
1
2
3
4
To Next Page
Loading...
