BODY ± Door
42-25
REMOVAL SERVICE POINTS
AA" POWER WINDOW AND REMOTE-CONTROLLED
MIRROR SWITCH ASSEMBLY/POWER WINDOW
SWITCH PANEL ASSEMBLY REMOVAL
1. Use the special tool to pry out the power window and
remote-controlled mirror switch assembly, first at the front
and then at the rear. (Refer to P.42-24, CLAW AND CLIP
POSITIONS.)
2. Use a flat-tipped screwdriver to disengage the lower claws
of the power window and remote-controlled mirror switch
assembly as shown in the illustration, and then remove
the power window and remote-controlled mirror switch
assembly.
AB" DOOR INSIDE HANDLE COVER REMOVAL
Use the special tool to pry out the rear part of door inside
handle cover, and then slide the door inside handle cover
in the direction of arrow shown to remove it.
AC" CLIP REMOVAL
Use a cloth to remove the clip as shown in the illustration.
INSTALLATION SERVICE POINTS
" AA WATERPROOF FILM INSTALLATION
Apply the specified sealant to the shown positions of waterproof
film, and then attach the waterproof film.
Specified sealant: 3M ATD Part No. 8625 or equivalent
Caution
Be sure to apply the sealant below the inner panel water
drain holes so as not to plug them.
MB990784
Claw
Door
trim
Switch bracket
Claw
Flat-tipped
screw driver
Power window and remote-controlled switch assembly
Section A ± A
MB990784
AA
A
A
Door trim
Claw
Waterproof film
Inner panel
water drain
hole
To Next Page
Loading...
