EXTERIOR ± Rear Wiper and Washer
51-16
INSTALLATION SERVICE POINT
"AA WIPER ARM AND BLADE ASSEMBLY
INSTALLATION
Install so that the wiper blade is positioned at the shown position
when the wiper arm stops.
Standard value (A): 33 ± 5 mm
"BA GROMMET INSTALLATION
Align the mating mark of grommet and the notch of installation
hole.
INSPECTION
WIPER MOTOR CHECK
Disconnect the wiring harness connector, and check the wiper
motor operation with the wiper motor remaining installed to
the body.
Wiper Motor Operation
Connect a battery to the wiper motor as shown in the illustration
and check the motor operation.
Wiper Motor Stop Position
1. Operate the wiper motor, and then disconnect the battery
to stop the wiper motor while the wiper motor is operating.
2. Reconnect the battery as shown in the illustration, and
confirm that after the motor starts turning, it stops at the
automatic stop position.
WASHER MOTOR CHECK
1. With the washer motor installed to the washer tank, fill
the washer tank with water.
2. Check that the water squirts out strongly when system
voltage is applied to terminal 2 and terminal 1 is earthed.
Back
door
glass
ceramic
end line
A
Grommet
Mating mark
Notch
Operation check
Battery
Stop position check
Battery
To Next Page
Loading...
