EXTERIOR ± Marks
51-20
(7) GDI mark
121 mm
Back door end line
Window moulding end line
42 mm
(6) Three diamonds mark
Back door end line
Key cylinder
165 mm
56 mm
2. INSTALLATION PROCEDURE
(1) Clean the mark installation surfaces on the body with
unleaded petrol.
(2) Peel off the backing paper from the reverse side of the
marks, and then attach the marks to the vehicle body
so that they fit properly into position.
Caution
When attaching the marks, the surrounding
temperature should be 20± 38C and the air should
be completely free from dust.
If the surrounding temperature is lower than 20C,
the marks and the places on the body where the marks
are to be attached should be heated to 20± 38C.
When the marks are attached, care should be used
not to allow bubble to enter between tape and the
body.
To Next Page
Loading...
