EXTERIOR ± Outside Door Mirror
51-22
REMOVAL SERVICE POINT
AA" MIRROR REMOVAL
Using a hand, push the upper part of mirror to tilt it. Apply
a protection tape as shown in the illustration. Insert a flat-tipped
screwdriver between a notch behind the mirror and the pivot
plate, and then pry off the lower part of mirror from the pivot
plate.
INSTALLATION SERVICE POINT
"AA MIRROR INSTALLATION
While holding the pivot plate with a flat-tipped screwdriver,
push the mirror to engage the clips at its lower part with the
pivot plate.
Section A ± A
Flat-tipped
screwdriver
Mirror
Pivot plate
Protection
tape
Notches
A
A
A
A
Section A ± A
Flat-tipped
screwdriver
Mirror
Pivot plate
A
A
A
A
To Next Page
Loading...
