EasyManua.ls Logo

Mitsubishi Pajero Pinin 1999 - Page 684

Mitsubishi Pajero Pinin 1999
919 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SRS ± Troubleshooting
52B-17
Code No.43 SRS warning lamp drive circuit system
(Lamp does not come on)
Probable cause
Open circuit is present for 5 successive seconds or more in SRS warning lamp
drive circuit.
However, once trouble is extinguished, this code, if displayed due to open circuit,
will be automatically erased.
D Defective wiring harnesses or connectors
D Blown bulb
D Malfunction of SRS-ECU
D Malfunction of combination meter
OK
NG
Check bulb for being blown.
Replace SRS-ECU.
OK
Replace combination
meter.
Check SRS warning lamp.
D Connect negative ) battery terminal.
D Ignition switch: ON
D Does lamp come on when SRS-ECU connector C-32 is
disconnected?
OK: Lamp illuminates
OK
Check trouble symptoms.
NG
Repair
NG
NG
Repair
OK
NG
Repair
Check the following connectors: C-02, C-06, C-07, C-32
Check wiring harness between SRS-ECU, combination meter
and ignition switch IG
1.
Code No.43 SRS warning lamp drive circuit system
(Lamp does not go out.)
Probable cause
Harness between SRS warning lamp and SRS-ECU is being shorted to earth.
However, once trouble is extinguished, this code will be automatically erased, and
SRS warning lamp will go out.
D Defective wiring harnesses or connectors
D Malfunction of SRS-ECU
D Malfunction of combination meter
NO
NO
Replace SRS-ECU.
OK
Replace SRS-ECU.
Check SRS warning lamp.
D Connect negative ) battery terminal.
D Ignition switch: ON
D Does lamp go out when combination meter connector C-07
is disconnected?
Check the following connectors: C-07, C-32
OK
Check trouble symptoms.
NG
Repair
Check wiring harness between SRS-ECU and combination meter
.
NG
NG
Repair
Code No.44 SRS warning lamp drive circuit system Probable cause
Short is present in SRS warning lamp drive circuit, or output transistor in SRS-ECU
is defective.
However, once trouble is extinguished, this code will be automatically erased, and
SRS warning lamp will go out.
D Defective wiring harnesses or connectors
D Malfunction of SRS-ECU
Check SRS warning lamp drive circuit system.
(Refer to P.52B-17)
OK
Replace SRS-ECU.

Table of Contents

Related product manuals