SRS ± SRS Maintenance
52B-25
11. Check steering wheel for excessive free play.
REPLACE ANY VISUALLY INSPECTED PART IF IT FAILS
THAT INSPECTION. (Refer to P.52B-41.)
Caution
The SRS may not activate if any of the above
components is not installed properly, which could
result in serious injury or death to the vehicle's driver
or front passenger.
FRONT SEAT BACK ASSEMBLY (SIDE AIR BAG
MODULE)
1. Check that there is no abnormality in the seat air bag
module deployment section.
2. Check that there is no connector damage, bent terminals
or clamping of the harness.
SIDE IMPACT SENSORS
1. Check that there is no bending or corrosion in the quarter
panel, inner.
2. Check that there is no denting, breakage, bending or
corrosion of the side impact sensor.
3. Check that there is no clamping of the harness, connector
damage or bent terminals.
NOTE
The illustration at left shows the side impact sensor (R.H.).
The position of the side impact sensor (L.H.) is symmetrical
to this.
Caution
The SRS may not activate if the side impact sensors
are not installed properly, which could result in serious
injury or death to the vehicle's driver or front
passenger.
Side air bag module
deployment section
Quarter
panel,
inner
Side
impact
sensor
To Next Page
Loading...
