SRS ± Post-collision Diagnosis
52B-29
FRONT IMPACT SENSORS
1. Check the front side member for deformation or rest.
2. Check the front impact sensor for dents, cracks,
deformation or rust.
3. Check the sensor harnesses for binding, the connectors
for damage, and the terminals for deformation.
Driver's and passenger's air bag modules
1. Check the covers for dents, cracks or deformation.
2. Check the connectors for damage, the terminals
deformities, and the harness for binds.
3. Check the air bag inflator cases for dents, cracks or
deformities.
4. Check the air bag modules for proper installation.
Clock spring
1. Check the clock spring connectors and protective tubes
for damage, and terminals for deformation.
2. Visually check the case for damage.
Steering wheel, steering column and intermediate joint
1. Check the driver's air bag module for proper installation
to the steering wheel.
2. Check the steering wheel for noise, binds or difficult
operation and excessive free play.
Harness connector (Instrument panel wiring harness)
Check the harness for binds, the connector for damage and
the terminals for deformation. (Refer to P.52B-4.)
Front side member
Front impact
sensor
Forward
<Driver's side>
<Front passenger's side>
Inflator case
Connector
Inflator case
Connector
Protective
tubes
Case
To Next Page
Loading...
