SRS ± SRS-ECU
52B-35
INSTALLATION SERVICE POINTS
" AA SRS-ECU INSTALLATION
Caution
Be sure to install the SRS-ECU properly. Otherwise, the
SRS air bags do not activate, which results in serious
injury or death of vehicle's occupants.
" BA BRACKET MOUNTING BOLT (EARTH BOLT)
INSTALLATION
Before installation, Refer to that the bolt is stamped mark
ªEº on the head.
" CA POST-INSTALLATION CHECK
1. Turn the ignition switch to ON.
2. Does the SRS warning lamp illuminate for about 7 seconds
and then go out for more than 5 seconds?
3. Yes: The SRS warning lamp is working properly
No: Go to Troubleshooting. (Refer to P.52B-8.)
INSPECTION
1. Check the SRS-ECU and brackets for dents, cracks or
deformation.
2. Check connector for damage, and terminals for
deformation.
Caution
If a dent, crack, deformation or rust are present, replace
the SRS-ECU with a new one.
NOTE
To check the SRS-ECU in other items than described
above, go to Troubleshooting. (Refer to P.52B-8.)
Earth bolt head mark
SRS warning lamp
To Next Page
Loading...
