Mitsubishi Pajero Pinin 1999 - Page 704

SRS ± Air Bag Modules and Clock Spring
52B-37
REMOVAL AND INSTALLATION
<Driver's air bag module, clock spring>
Pre-removal Operation
D Put Steering Wheel and Front Wheels in
Straight-ahead Position. Remove Ignition Key.
D Disconnect the Negative (±) Battery Terminal.
A
3
0.69 Nm
A
B
Column switch
3
NOTE
: Claws
Claw
Section A ± A
Claw
B
Section B ± B
2
1
9 Nm
9 Nm
41 Nm
Driver's air bag module removal
steps
AA" 1. Driver's air bag module
AB" 2. Steering wheel
Driver's air bag module installation
steps
" AA D Pre-installation inspection
" CA 2. Steering wheel
1. Driver's air bag module
D Negative (±) battery cable connection
" DA D Post-installation check
Clock spring removal steps
AA" 1. Drive's air bag module
AB" 2. Steering wheel
D Lower column cover
AC" 3. Clock spring
Clock spring installation steps
" AA D Pre-installation check
" BA 3. Clock spring
D Lower column cover
" CA 2. Steering wheel
1. Driver's air bag module
D Negative (±) battery cable connection
" DA D Post-installation inspection