SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-53
(5) Using pliers, cut the seat belt pre-tensioner connector
from the harnesses. Connect the deployment
harnesses to each harness that has been cut and
insulate the connections with plastic tape.
(6) Route the deployment harness out of the vehicle.
(7) Fully close all door windows, close the doors and
place a cover over the vehicle to minimize the amount
of noise.
Caution
If the glass is damaged, it may break, so the car
must be covered.
(8) Disconnect the deployment harnesses as far from the
vehicle as possible and connect the wires to the
terminals of the battery removed from the vehicle.
Operate the seat belt pre-tensioner.
Caution
1) Before operating the seat belt pre-tensioner
in this manner, first check to be sure that there
is no one in or near the vehicle. Wear safety
glasses.
2) The operation of the seat belt pre-tensioner
makes the inflator very hot. Before handling
the inflator, wait more than 30 minutes for
cooling.
3) If the seat belt pre-tensioner fails to operate
when the procedures above are followed, do
not go near the seat belt pre-tensioner. Contact
your local distributor.
(9) After operation of the seat belt pre-tensioner, discard
as specified in the procedure (Refer to P.52B-60).
Seat belt pre-
tensioner
Deployment
harnesses
Shorted
Insulation
tape
Cover
Deployment harnesses
To Next Page
Loading...
