SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-55
(4) Take the SRS air bag adapter harness that is
connected to the wires, pass it beneath the old tyre
wheel assembly, and connect it to the drive's air bag
module.
(5) With the driver's air bag module upwards, place it in the
wheel of old tyre and secure with the wire tied to the
bolt.
Caution
Slack the deployment harnesses below the wheel.
If deployment harnesses are tight, the reaction
when the air bag deploys could damage the
adaptor harness.
(6) Place three old tyres without wheels on top of the
tyre secured to the driver's air bag module.
(7) Disconnect the deployment harnesses as far from the
driver's air bag module as possible and connect the
wires to the terminals of the battery removed from
the vehicle. Then deploy.
Caution
1) Before the deployment, be sure that no one
is near the driver's air bag module.
2) The deployment of the driver's air bag makes
the inflator very hot. Before handling the
inflator, wait more than 30 minutes for cooling.
3) If the driver's air bag module fails to deploy
when the procedures above are followed, do
not go near the module. Contact your local
distributor.
(8) After deployment of the driver's air bag module, discard
as specified in the procedure (Refer to P.52B-60).
Driver's air bag module
Deployment
harnesses
Tyres without wheels
Deployment harnesses
Deployment harnesses
To Next Page
Loading...
