SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-57
(6) Disconnect the deployment harnesses as far from the
front passenger's air bag module as possible and
connect the harnesses to the battery removed from
the vehicle.
Caution
1) Before the deployment, see that no one is near
the front passenger's air bag module.
2) The deployment makes the inflator of the front
passenger's air bag very hot. Before handling
the inflator, wait more than 30 minutes for
cooling.
3) If the front passenger's air bag module fails
to deploy although the procedure is respected,
do not go near the module. Contact your local
distributor.
(7) After deployment of the front passenger's air bag
module, discard as specified in the procedure (Refer
to P.52B-60).
Side air bag module
(1) Remove the front seat back assembly with side air
bag module from the vehicle. (Refer to P.52B-36.)
Caution
Once disconnected, both electrodes of the side
air bag module connector short automatically to
prevent accidental deployment caused by static
etc. Still, in consideration of the accidental
deployment, store the air bag module on flat place
with deployment surface facing up. Also, do not
put anything on it.
(2) Prepare two wires longer than 6 m for deployment and
connect the terminals in one end to short-circuit. This
is to prevent accidental deployment caused by static
etc.
(3) Touch the vehicle's body with bare hands to discharge
static in you.
Caution
Never fail to do Step (3) in order to prevent
accidental deployment caused by static.
(4) Using pliers, cut the side air bag module connector
from the harnesses. Connect the deployment
harnesses to each harness that has been cut and
insulate the connections with plastic tape.
Deployment harnesses
Shorted
Deployment harnesses
6 m or longer
Front seat back assembly
Insulation
tape
Deployment harnesses
Shorted
To Next Page
Loading...
