Mitsubishi Pajero Pinin 1999 - Page 741

CHASSIS ELECTRICAL ± Ignition Switch and Immobilizer System
54A-14
REMOVAL SERVICE POINTS
AA" STEERING LOCK CYLINDER REMOVAL
1. Insert the key in the steering lock cylinder and turn it to
the ªACCº position.
2. Using a cross-tip (+) screwdriver (small) or a similar tool,
push the lock pin of the steering lock cylinder inward and
then pull the steering lock cylinder toward you.
INSPECTION
IGNITION SWITCH CONTINUITY CHECK
1. Remove the column cover lower and upper.
2. Disconnect the wiring connector from the ignition switch.
3. Operate the switch, and check the continuity between
the terminals.
Ignition key
iti
Terminal No.
g y
position
1 2 4 5 6
LOCK
ACC
ON
START
KEY REMINDER SWITCH CONTINUITY CHECK
Disconnect the key reminder switch connector with the switch
attached to the vehicle, and then check the continuity between
the terminals.
Ignition key
Terminal No.
g y
4 6
Removed
Inserted
Cross-tip (+) screwdriver