EasyManua.ls Logo

Mitsubishi Pajero Pinin 1999 - Page 750

Mitsubishi Pajero Pinin 1999
919 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHASSIS ELECTRICAL ± Combination Meters
54A-23
Inspection Procedure 6
GDI ECO indication lamp does not illuminate.
Probable cause
GDI ECO indication lamp is illuminated by GDI ECO indication lamp-ECU.
When it does not illuminates, GDI ECO indication lamp bulb may be blown, or
combination meter, power supply circuit of GDI ECO indication lamp-ECU or GDI
ECO indication lamp-ECU may be malfunctioning.
D ECO indication lamp bulb blown
D Malfunction of combination meter
D Malfunction of GDI ECO indication lamp
D Malfunction of engine-ECU
D Damaged harness or connectors
Replace engine-ECU.
NG
Check trouble symptoms.
Replace GDI ECO indication lamp-ECU.
NG
Check harness wire between GDI ECO indication lamp-ECU and
engine-ECU, between GDI ECO indication lamp-ECU and rheostat.
NG
Check trouble symptoms.
Repair
NG
OK
Check trouble symptom.
Check following connectors: C-55, C-07
OK
NG
Check bulb for being blown.
NG
Check GDI ECO indication lamp at GDI ECO indication lamp-ECU
connector C-55
D Disconnect connector and measure at harness side.
D Ignition switch: ON
D Connect between terminal 2 and body earth
OK: Lamp illuminate
Other illumination lamps normally darken with rheostat.
OK
Check the rheostat. (Refer to P.54A-44.)
NG
Check the harness wires between combination meter and GDI
ECO indication lamp-ECU.
NG
Check following connectors: C-02 <L.H. drive vehicles>, C-76,
C-74
Measure at GDI ECO indication lamp-ECU connector C-55
D Disconnect connector and measure at harness side.
D Ignition switch: ON
D Voltage between terminal 1 and body earth
OK: System voltage
OK
Repair
NG
OK
Check trouble symptom.
NG
Check the harness wires between ignition switch (IG) and GDI
ECO indication lamp-ECU.
NG
Check following connector: C-55
Measure at GDI ECO indication lamp-ECU connector C-55
D Disconnect connector at measure harness side.
D Continuity between terminal 8 and body earth
OK: Continuity
OK
Repair
NG
OK
Check trouble symptom.
NG
Check harness wire between GDI ECO indication lamp-ECU and
body earth.
NG
Repair
Check following connectors: C-55, C-83, C-29,C-17
OK
OK

Table of Contents

Related product manuals