Mitsubishi Pajero Pinin 1999 - Page 804

CHASSIS ELECTRICAL ± Multi-center Display <Middle Grade>
54A-77
INSPECTION PROCEDURE 5
Abnormal driving data displays.
D Abnormal average fuel consumption and average speed displays.
D Abnormal cruising distance displays.
1. When average fuel consumption and average speed displays are abnormal.
OK
OK
YES
Check the connector: C-52
NG
Repair
OK
Check the multi-center display unit con-
nected into system on service mode.
Does MU light on the display?
Check the connections between the
multi-center display unit and the en-
gine-ECU.
Replace the multi-center display unit.
NG
Check the harness between the multi-
center display unit and the engine-ECU,
and Replace the if necessary.
NG
NO
Check the harness.
NG
OK
Disconnect MUT-II
Measure at multi-center display con-
nector C-52.
D Connector disconnected.
D Voltage between terminal (36) and
body earth
OK: Ignition switch ON: System
voltage
NG: Ignition switch OFF: 0 ± 1 V
Check a voltage on (5) terminal of C-53
connector after C-53 connector shall
be out.
D ignition switch : ON
OK: Low
NG: more than 80% of system
voltage
Check the harness between multi-cen-
ter display unit and junction block and
Replace the if necessary.
2. When cruising distance display is abnormal.
NG
OK
Does the service mode show fuel amount correctly?
YES
NO
An inaccurate fuel amount may be displayed for a while after
refuelling.
In addition, it depends on road and driving conditions whether an
accurate fuel amount is displayed.
Measure at multi-center display connector C-52.
D Connector disconnected.
D Voltage between terminal (33) and body earth
OK: 0.1 ± 3.0 V
NG
OK
Replace the multi-center display unit.
Check the harness between multi-center display unit and the fuel
gauge unit, and Replace the if necessary.
Carry out troubleshooting according to procedure 5.1.
Are the average fuel consumption and average vehicle speed
displayed normally?
End (no abnormality)
Relative unit : Combination meter, fuel gauge unit