CHASSIS ELECTRICAL ± Multi-Center Display <High Grade>
54A-84
(4) The next mode is the sensor checking mode. Press the
F1 switch to start sensor checking.
If you would like to proceed to the next checking operation
without carrying out sensor checking, press the F6 switch.
(5) When sensor checking starts, the gyro output will be
checked first while the vehicle is stopped, so make sure
that the vehicle is stopped for this check.
If the vehicle is moving when the sensor checking starts,
the vehicle speed sensor will be shown as defective.
Follow the guidance message on the multi-center display.
(6) Next, drive the vehicle for approximately 10 meters while
changing the running direction in order to check the vehicle
speed pulse and the gyro sensor output. The sensor
checking will then be completed. If there is an open circuit
in the vehicle speed sensor, sensor checking will not
complete even after the vehicle has travelled more than
10 meters. In this case, press the F5 switch to stop
checking.
If the vehicle does not move or there is an open circuit
in vehicle speed sensor, the vehicle speed sensor will
be shown as defective.
(7) When sensor checking is completed, the check results will
appear on the screen. After checking the results, press the
F1 switch to proceed to the next check.
(8) The next mode is the vehicle signal checking mode. The
lighting switch condition, ignition key position, shift lever
selection (R or a position other than R) and the power
supply voltage drop will be appear on the screen. Check
that the details displayed match the actual vehicle signals,
and then press the F1 switch.
If the vehicles does not move or there is an open circuit
in vehicle speed sensor, the vehicle speed sensor will
be shown as defective.
To Next Page
Loading...
