Mitsubishi Pajero Pinin 1999 - Page 832

CHASSIS ELECTRICAL ± Multi-Center Display <High Grade>
54A-105
ERROR CODE TABLE <ACCORDING TO SCREEN DISPLAY>
Error Code
No.
Error Details Detection Method (Reference) Refer-
ence
Page
1011 Ambient temperature sensor not con-
nected during diagnosis
Connection checking 54A-105
1021 Fuel gauge not connected during diagnosis Connection checking 54A-106
1031 GPS abnormality during diagnosis Connection checking 54A-106
1041 Engine-ECU not connected during diagno-
sis
Connection checking 54A-106
1051 SWS not connected during diagnosis Connection checking 54A-106
1091 CD drive too hot during diagnosis Connection checking 54A-106
1092 ± 1096 CD drive abnormality during diagnosis Connection checking 54A-107
10A1, 10B1 Memory of navigation unit abnormality
during diagnosis
Connection checking 54A-107
20D1, 30D1 Vehicle speed pulse abnormality during
diagnosis
Sensor checking 54A-107
20E1, 20E2,
30E1, 30E2
Gyro level abnormality during diagnosis Sensor checking 54A-107
INSPECTION PROCEDURES FOR EACH ERROR CODE <ACCORDING TO
SCREEN DISPLAY>
Error Code No. 1011
Were the wiring check instructions followed?
NO
Repeat the wiring check.
YES
Repeat the wiring check. If the same problem occurs, check ambi-
ent temperature sensor.
Replace the ambient temperature sensor.
OK
Measure at the multi-center display connector B-08.
D Disconnect connector.
D Resistance between terminal (23) and body eartth.
OK: 500 Ω ± 100 kΩ
NG
Check the harness between C-52 and A-89.
OK
Replace the multi-center display.
NG