EasyManua.ls Logo

Mitsubishi Pajero Pinin 1999 - Page 854

Mitsubishi Pajero Pinin 1999
919 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SWS ± Troubleshooting
54B-19
Inspection Procedure D-3
Power window: Power window sub switch can not operate
passenger's window.
Probable cause
The cause is probably a malfunction of the power window main switch or
driver's side power window motor, or an abnormality in the power supply
circuit.
D Malfunction of power window sub switch
D Malfunction of passenger's power window motor
D Malfunction of harness wire or connector
Check the power window sub switch. (Refer to GROUP 42 ± Door.)
NG
Replace the power window sub switch.
OK
Measure at power window sub switch connector E-04 <L.H. drive
vehicles> or E-09 <R.H. drive vehicles>.
D Disconnect connector and measure at harness side.
D Continuity between terminal 4 and body earth.
OK: Continuity
NG
Check the following connectors:
<L.H. drive vehicles> C-21, E-04
<R.H. drive vehicles> C-45, E-09
OK
Check trouble symptoms.
NG
Repair
OK
Check the following connectors:
<L.H. drive vehicles> E-04, E-06
<R.H. drive vehicles> E-09, E-12
NG
Check the harness wire between power window sub switch and
body earth.
OK
Check trouble symptoms.
NG
Repair
NG
(1) NG
Check the following connectors:
<L.H. drive vehicles> C-21, C-71, E-06
<R.H. drive vehicles> C-45, C-71, E-12
NG
Check the harness wire between power window sub switch and
passenger's power window motor.
NG
Repair
OK
Check trouble symptom
NG
Repair
NG
Check the harness wire between passenger's power window motor
and power window relay.
NG
Repair
NG
Check the harness wire between passenger's power window motor
and body earth.
(2) NG
Check the following connectors:
<L.H. drive vehicles> C-21, E-06
<R.H. drive vehicles> C-45, E-12
OK
Check trouble symptom
Measure at passenger's power window motor connector E-06
<L.H. drive vehicles> or E-12 <R.H. drive vehicles>.
D Disconnect connector and measure at harness side.
D Turn the ignition switch to ON position.
(1) Voltage between terminal 1 and body earth.
OK: System voltage
(2) Continuity between terminal 3 and body earth.
OK: Continuity
OK
Replace the passenger's power window motor.

Table of Contents

Related product manuals