SWS ± Troubleshooting
54B-21
Inspection Procedure D-6
Power window: When the glass is raised, it then lowers
automatically.
Probable cause
If the sliding resistance is too large when the glass is being raised, it is judged
that something is jammed in the window, and the window is lowered by
approximately 150 mm.
D Incorrect window glass adjustment
D Glass slider is incorrectly installed or warped
D Malfunction of power window motor
Check the power window operating currant. (Refer to GROUP
42 ± Door.)
NG
Adjust the window glass. (Refer to GROUP 42 ± Door.)
OK
Replace the power window motor.
Check trouble symptoms.
NG
Replace the window regulator assembly.
Inspection Procedure D-7
Power window: The glass is jammed in the window. Probable cause
The cause may be a malfunction of the revolution detection sensor in the
power window motor.
D Malfunction of power window motor
Replace the power window motor.
Inspection Procedure D-8
Power window: When the glass is fully raised, it then
lowers automatically.
Probable cause
The cause may be a malfunction of the revolution detection sensor in the
power window motor.
D Malfunction of power window motor
After disconnecting the battery terminals, set the limit switch.
(Refer to GROUP 42 ± DOOR.)
Check trouble symptoms.
NG
Replace the power window motor.
To Next Page
Loading...
