HEATER, AIR CONDITIONER AND VENTILATION ±
Compressor and Tension Pulley
55-29
REASSEMBLY SERVICE POINTS
" AA SNAP RING INSTALLATION
Install the snap ring so that the tapered surface is at the outer
side.
" BA AIR GAP ADJUSTMENT
Check whether or not the air gap of the clutch is within the
standard value.
Standard value: 0.25 ± 0.55 mm
NOTE
If there is a deviation of the air gap from the standard value,
make the necessary adjustment by adjusting the number of
shims.
Field coreRotor
Snap ring
Tapered part
AV1079AE
To Next Page
Loading...
