INDEX
Page Page
PERIODICAL INSPECTION 1 Screen 201
PERIODICAL INSPECTION 2 Screen 202
PERIODICAL INSPECTION 3 Screen 203
PERIODICAL INSPECTION Screen 201
PLC ALARM Screen 207
POWER STANDBY Screen 211
POWER-RELATED 131
PRECAUTIONS FOR OPERATORS 4
Precautions for the Machine Equipped with High-Speed
Spindle 87
Precautions when Operating Special Specification
Machines 26
Precautions when Registering Tools 82
Preparation 235
Preparation Prior to Setting Workpiece Zero Point 100
Pre-Program Check Confirmation 116
Press the Automatic Operation Button [STOP] to Execute or
Cancel an Emergency Stop 67
Prior to Operation 127
PROCESSING TIME STAMP Screen (Option) 188
PROGRAM CHECK 116
Program Check Preparation 116
Program Check Procedure 117
PROGRAM CHECK Screen 181
PROGRAM CHECK Screen in MDI Mode 186
Program Creation Procedure 112
Program Edit Keys 167
PROGRAM EDITING 227
Program Editing 230
Program Input (Reading) from User Memory Area 187
Program Input (Reading) from User Memory Area to NC
Memory 242
Program Input Operation Procedure 236
Program Input/Output in the NC Memory/User Memory
Area 241
PROGRAM LIST Screen 186
Program Number Search 228
Program Output (Punching) from the NC to the User Memory
Area 242
Program Output (Punching) to User Memory Area 187
Program Output Operation Procedure 236
PROGRAM RESTART Screen (Option) 188
Programming Method 114
R
[RAPID OVERRIDE] (Rapid Traverse Rate Override)
Switch 152
Rapid Traverse Operation 151
Reference Face Measurement 101
Registering Excerpt Programs 235
Registering Group Name 233
Registering O Numbers in Groups 234
Registration
Group Registration of Program Numbers 233
Releasing Door Interlock Function 78
Removing a Tool from the Spindle 93
Removing Tools 90
Replacing Words 232
(RESET) Key 168
Resetting Data 249
Returning the Tool 255
RS232C Interface Connector 132
RS232C Interface Connector in the Electrical Cabinet 136
S
SAFETY DEVICES 7
Safety During Machine Operation (1) 12
Safety During Machine Operation (2) 13
Safety Precautions 9
Screen List 169
Search Function 228
Sequence Number Search 228
SETTING (Menu) Screen 207
SETTING Screen 212
Setting the Display/Non-Display State of Each Counter
250
Setting the Empty Pot 84
Setting the Magazine Tool 84
Setting the Next Tool 85
Setting the Retraction Position by G10.6 254
Setting the Sensor Tool 85
Setting the Spindle Tool 84
Setting Values for Multi Counter 248
SETUP OPERATION 17
SETUP OPERATION BASIC SETTING Screen Setting
96
Setup Parameter Screen 196
Setup Station Door Lock Device 81
(SHIFT) Key 168
Shortcut Key Functions 169
SHORTCUT SETTING Screen 214
Signal Tower 48, 132
Signs and Symbols 113
SIMULATION PROGRAM SELECT Screen 217
[SINGLE BLOCK] (Single Block) Button 143
Soft-Key Registration 234
Soft-Keys 165
To Next Page
Loading...
