CHANGE/VIEW MTSX RSS
6-68 68P81074C50
Hot Keypad (DTMF)
Use up/down arrow keys to enable DTMF while transmitting operation for this personality. When this feature is
enabled, the keypad is live during all dispatch operation. Pressing any digit 0 - 9, *, or # will cause that digit to be
transmitted. Factory default is Disabled.
Status
Enables/Disables the transmission of pre-determined Status messages.
IMPORTANT NOTE
The radio controls may require additional setup for your Status configuration.
Also refer to the Radio Wide Button/Switch/Menu screen (F4/F3/F3). In
addition, Status number and name aliasing is available on the Trunking System
Options screen (F4/F4/F3/F9).
Message
Enables/Disables the transmission of pre-determined canned messages.
IMPORTANT NOTE
The radio controls may require additional setup for your Message configuration.
Also refer to the Radio Wide Button/Switch/Menu screen (F4/F3/F3). In
addition, Status number and name aliasing is available on the Trunking System
Options screen (F4/F4/F3/F9).
Call ID List
This is the number of the Call ID list that this personality will use for Private Call.
IMPORTANT NOTE
Refer to the Trunking Wide Call List screen (F4/F4/F6). The radio controls may
require additional setup for your Private Call configuration on the Radio Wide
Button/Switch/Menu screen (F4/F3/F3).
The Private Call and Call Alert features must have a call list assigned for Unlimited and List operation. Factory
default is 1 list per trunking system.
Scan List
IMPORTANT NOTE
Refer to the Radio Wide Menu screen (F4/F3/F5). The radio controls may
require additional setup for your Scan configuration on the Radio Wide
Button/Switch/Menu screen (F4/F3/F3).
To change or view the scan list, select the Scan Menu (F4/F3/F5). Trunking personalities may use Subfleet,
Priority Monitor, and Talkgroup type scan lists. Factory default is None.
To Next Page
Loading...
Need help?
General
