6 Maintenance VJ-1624 OPERATION MANUAL
6-4
CAUTION
• Before operation, make sure to read the Material Safety Data Sheet (MSDS).
• When handling ink cartridges or ink packs, pay attention so that ink does not get
into your eyes or stick to your skin.
If ink gets into your eyes or sticks to your skin, immediately wash it off with water.
Failing to do so might cause irritation or light inflammation of eyes.
In case of any abnormality, consult a physician immediately.
• Do not disassemble ink cartridges or ink packs.
If disassembled, there is a possibility that ink might come into contact with eyes or
skin.
NOTE
• Do not share the ink cartridge once installed with another printer. The cartridge will not be usable
from that time onward.
• Do not give ink cartridges or ink packs strong shakes.
Doing so may cause ink leakage.
• Do not disassemble ink cartridges.
A disassembled ink cartridge or ink packs cannot be used.
• When an ink cartridge or ink pack is moved from a cold place to warm place, keep the ink cartridge
for 3 hours or more in the new printing environment before printing.
• Do not refill an ink cartridge or ink pack with ink.
It may result in abnormal printing.
• Insert or remove the ink cartridge and high capacity pack adapter at the time of replacement only.
Inserting or removing the ink cartridge and high capacity pack adapter except at the time of
replacement may result in incorrect printing.
(1) Replacing 220ml and 440ml ink cartridges
1. Confirm that the printer is turned ON.
NOTE
• Do not replace ink cartridges when the printer is turned OFF.
The remaining ink may not be detected correctly, causing abnormal printing.
2. Remove the ink cartridge that you want to replace from the slot.
a. For 220ml ink cartridges
To Next Page
Loading...
Need help?
General