MUTOH VJ-1624 - Disposal of waste fluids

VJ-1624 OPERATION MANUAL 6 Maintenance
6-41
6.3 Disposal of waste fluids
The timing and method for the disposal of waste fluid are described below.
(1) Disposal timing
Dispose of waste fluids in the following cases:
a. When the waste fluid tank is more than half full.
b. When "Waste Ink Tank Full" is displayed on the operation panel.
(2) Disposal method
Follow the procedure below to dispose of waste fluid.
WARNING
• The waste fluid from the printer falls under the category of waste oil (waste ink) of
industrial waste (out of the 19 items of general waste from business activities).
You are obligated to properly dispose of waste fluid in compliance with Wastes
Disposal and Public Cleansing Act and local ordinances.
Delegate disposal to an industrial waste disposal contractor.
1. Ready an empty container such as a supply waste fluid bottle, to contain the waste fluid.
2. Lay a protective material on the floor under the waste fluid tank.
3. Open the waste fluid valve, and transfer the waste fluid to the container.
NOTE
• When transferring the waste fluid to the empty container, the waste fluid may spatter.
Make sure to put the container close to the waste fluid valve.
1
2