7 Troubleshooting VJ-1624 OPERATION MANUAL
7-6
(5) The media veers during printing
7.1.4 Printing-related troubleshooting
(1) Printing is partially stained or incomplete
NOTE
• Proper print quality may not be obtained with the media other than the recommended one.
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
(3) Printing is blurred
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the loading position of the media correct? Set the media correctly.
3.4.2 Setting
Roll Media
3 Is the roll media loaded correctly? Load the roll media correctly.
3.4.1 Loading
roll media
No. Possible cause Remedy Reference
1 Does the media include moisture? Replace it with new media.
6.1.2 Replacing
Roll Media
2 Are you using the folded or wrinkled media?
3 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Media type
5.1.1.1.8
Vacuum Fan menu
No. Possible cause Remedy Reference
1 Is the loading position of the media correct? Set the media correctly.
3.4.2 Setting
Roll Media
2 Did you set up the origin and print position? Cancel or reset the settings of the origin and
print position.
5 Panel setup
menu
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Are you using the thick or thin media? Use the recommended media.
4.2.1 Media type
3 Is the media printed on the printing surface? Confirm the printing surface of the media and
set it correctly.
3.4 Loading
media
4 Did you perform Alignment? Perform Alignment.
3.6 Adjust Print
To Next Page
Loading...
Need help?
General