5 Panel setup menu VJ-1624 OPERATION MANUAL
5-20
NOTE
• Set the media width that is set in the Media Width menu when setting "Off" in the Media detection
menu.
5.1.5 Media Width menu
• When the Media detection menu is set to "Off", the media cannot be cut automatically.
5.1.5 Media Width menu
Specifies the media width between 7mm away from the right edge of the platen and the left end if media
detection is not performed during media initialization.
(1) Media Width menu
Displays the detected media width if media detection is performed during media initialization.
(2) Media Width menu
NOTE
• If the media is loaded as shown in the illustration and media detection is not performed, the printing
may be performed between the right edge of the platen and the media.
5.1.8 Origin menu
Setup item Setting Description
Init. Off The media is not detected.
Top & Width Detect the media width and edge while initializing the media.
<Width> Detect the media width while initializing the media.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
No. Name
1 Roll media
2 Media width (when not detected)
1
2
7mm
To Next Page
Loading...
Need help?
General