VJ-1624 OPERATION MANUAL 7 Troubleshooting
7-5
(3) The wrong media size is set during initialization
(4) Media jams frequently occur
NOTE
• If media other than the recommended one is used, correct media feeding cannot be assured.
3 Is the media loaded at an angle? Set the media straight.
3.4.2 Setting
Roll Media
4 Are there any foreign materials such as paper
attached to the pressurizing roller?
Clean the pressurizing roller.
6.2.2 Cleaning
the inside of the
printer
5 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
Only use the printer in an environment that is
specified for use.
Installation
manual
6 Are you using folded, torn or rolled media? Replace the media.
4.2.2 Cautions
on handling media
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the media loaded at an angle? Set the media straight.
3.4.2 Setting
Roll Media
3 When the media is set, does it curl upward? Straighten the media or set a new media.
3.4.2 Setting
Roll Media
4 Is the printer used in an environment other
than the one specified, such as near an air
conditioner?
Only use the printer in an environment that is
specified for use.
3.4.1 Loading
roll media
5 Are you using media that has been printed on
already?
Use a new media.
4.2.1 Media type
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the media used in an environment other than
the one specified?
Use the media in a dedicated environment.
4.2.2 Cautions
on handling media
3 Are you using the old media? Replace it with new media.
6.1.2 Replacing
Roll Media
4 Are you using the folded or wrinkled media?
5 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Media type
5.1.1.1.8
Vacuum Fan menu
No. Possible cause Remedy Reference
To Next Page
Loading...
Need help?
General