7 Troubleshooting VJ-1624 OPERATION MANUAL
7-4
7.1.3 Media-related troubleshooting
(1) The media slips or is torn during initialization
NOTE
• If the media is jammed or torn, remove it according to "7.3 The media is jammed".
(2) The media is crumpled during initialization
NOTE
• If the media is jammed or torn, remove it according to "7.3 The media is jammed".
4 Does the Power lamp on the operation panel
turn on after sending printing data from the
computer?
If the Power lamp does not turn on, contact the
computer manufacturer.
—
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the loading position of the media correct? Set the media correctly.
3.4.2 Setting
Roll Media
3 Is the roll media loaded correctly? Load the roll media correctly.
3.4.1 Loading
roll media
4 Are there any foreign materials such as paper
attached to the pressurizing roller?
Clean the pressurizing roller.
6.2.2 Cleaning
the inside of the
printer
5 Is the printer being used in an environment
other than the one specified, such as in direct
sunlight?
Only use the printer in an environment that is
specified for use.
Installation
manual
6 Are you using folded, torn or rolled media? Replace the media.
4.2.2 Cautions
on handling media
7 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Media type
5.1.1.1.8
Vacuum Fan menu
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media type
2 Is the loading position of the media correct? Set the media correctly.
3.4.2 Setting
Roll Media
No. Possible cause Remedy Reference
To Next Page
Loading...
Need help?
General