3 Before using VJ-1624 OPERATION MANUAL
3-14
NOTE
• If the printer performs the nozzle check printing immediately after initial ink replenishment is
complete, the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow "6.2.3 Head cleaning" and refill a small amount of ink. Then, check the
printing result.
If there is no improvement in the print result even after refill a small amount of ink, leave the
printer unused for an hour or more. Then, refill a small amount of ink again and check the print
result.
If there is still no improvement, contact your local MUTOH dealer.
3.3.2 Installing 440ml ink cartridges
Follow the procedure below to install the ink cartridge.
1. Check the angle of the ink cartridge slot to see if the insertion angle of the ink cartridge is vertical.
• If the insertion angle of the ink cartridge is not vertical, change the angle.
3.3.5 Changing the angle of the ink cartridge slot
NOTE
Make sure that insertion of 440ml cartridge is from above the printer. If the cartridge is inserted
obliquely, the cartridge may fall over.
2. Turn the printer ON.
No. Name
1 Ink cartridge slot
1
To Next Page
Loading...
