VJ-1624 OPERATION MANUAL 5 Panel setup menu
5-23
5.1.8 Origin menu
Sets the beginning of printing (origin) of the print data.
Set the menu when reprinting on the margin with changing the printing data position to the printed
media.
NOTE
• When Output Mode menu is set to "Take-up", the set value X (media feeding distance) becomes 0
mm to 15000 mm.
5.1.6 Output Mode menu
• Depending on the set value of the side margin, the maximum set value of Y (print head transferring
distance) decreases.
5.1.3 Side Margin menu
Setup item Setting Description
Method of Cut SingleCut-2 steps Cuts at a shorter process than SingleCut-3 steps method.
Suitable for media with a narrow width.
<SingleCut-3 steps> Normal cutting method.
DoubleCut-2 steps Set when the media is not cut with SingleCut-2 steps method.
Suitable for media with a narrow width.
DoubleCut-3 steps Set when the media is not cut with SingleCut-3 steps method.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
To Next Page
Loading...
Need help?
General