VJ-1624 OPERATION MANUAL 6 Maintenance
6-29
4. Press the [Cleaning] key on the operation panel for at least two seconds.
• Start Head cleaning.
• "Cleaning **%" is displayed on the operation panel.
• After Head cleaning is complete, the operation panel shifts to Normal.
NOTE
• If blurs or lacking parts in printed media do not disappear with one time of Head cleaning,
perform Strong cleaning.
• If blurs or lacking parts in printed media do not disappear with several times of Head cleaning,
refer to "7 Troubleshooting", and take appropriate measures.
6.2.4 Cleaning the cleaning wiper
This section describes how to clean the cleaning wiper.
(1) Time for cleaning
Once a week, or when blurs or lacking parts appear on printed media after Head cleaning.
(2) Cleaning procedures
Follow the procedure below to clean the cleaning wiper.
NOTE
• Use the cleaning stick to clean the cleaning wiper.
For details of the cleaning stick, refer to "8.3 Options/Supply list".
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
To Next Page
Loading...
Need help?
General