VJ-1624 OPERATION MANUAL 3 Before using
3-23
CAUTION
• Do not perform the following operations during ink filling. If filling is interrupted,
ink will be lost when filling is resumed.
• Do not turn OFF the power of the printer.
• Do not unplug the power cable of the printer.
• Do not open the front cover.
• Do not open the maintenance cover.
• Do not raise the media loading lever.
• When the initial ink charge is complete, "SubTank Refill **%" is displayed on the operation
panel, and the printer starts filling the subtank.
• When "100%" is displayed, the subtank ink replenishment is complete.
• After the subtank ink replenishment is complete, "Media End" is displayed on the operation
panel.
NOTE
• If the printer perform the nozzle check printing immediately after initial ink replenishment is
complete, the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow "6.2.3 Head cleaning" and refill a small amount of ink. Then, check the
printing result.
If there is no improvement in the print result even after refill a small amount of ink, leave the
printer unused for an hour or more. Then, refill a small amount of ink again and check the print
result.
If there is still no improvement, contact your local MUTOH dealer.
3.3.4 When using the high capacity pack adapter for the printer
whose ink is charged for the first time
The air inside the high capacity pack adapter goes into the printer ink tube and may cause nozzle
clogging. Make sure to perform initial ink charge from the Cleaning menu in the following case.
• When using the high capacity pack adapter for the printer whose ink is charged for the first time
• When the high capacity pack adapter has been used, and after replacing it with a new one and
installing it to the printer
5.3 Cleaning menu
To Next Page
Loading...
Need help?
General