MUTOH VJ-1624 - Moving or transporting the printer

VJ-1624 OPERATION MANUAL 6 Maintenance
6-43
6.4 Moving or transporting the printer
This section describes how to move or transport the printer.
6.4.1 Moving the printer
This section describes how to move the printer.
CAUTION
• Move the printer maintaining a horizontal position.
• Do not slant the printer, prop it against a wall or turn it upside down.
There is a possibility that ink inside the printer may leak.
Moreover, normal operation after shifting (to these positions) cannot be
guaranteed.
(1) Preparation before moving
When using the dedicated stands, follow the procedure below to move the printer.
1. Make sure that the printer is turned OFF.
3.2.2 Turning the power OFF
2. Dispose of waste fluid.
6.3 Disposal of waste fluids
3. Remove all the cables, such as the power cable.
4. Loosen the four adjusters of the stand as shown in the next illustration.
5. Move the printer.
NOTE
• The casters supplied with the dedicated stand are manufactured for little movement in flat
indoor areas, not for transporting equipment.