MUTOH VJ-1624 - Slant Check Menu; Auto Cleaning Menu

VJ-1624 OPERATION MANUAL 5 Panel setup menu
5-27
5.1.14 Slant Check menu
Sets up slanting detection during media loading.
5.1.15 Auto Cleaning menu
Configure the settings for the auto-cleaning operation.
TIP
• The cleaning mode reflects the settings in the operation panel.
6.2.3 Head cleaning
Setup item Setting Description
Strike Wait <0.0 sec.> to 0.1 sec. to 5.0
sec.
Sets the overwrite wait time.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Slant Check Off Slant Check is not performed.
<On> Slant Check is performed.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Auto Cleaning WaitingTime Set the value for auto-cleaning in standby mode.
5.1.15.1 Idle Auto Cleaning
Print time Set the value for auto-cleaning in printing mode.
5.1.15.2 Printing Mode Auto Cleaning
Before printing Set the value for auto-cleaning in pre-printing mode.
5.1.15.3 Pre-printing Mode Auto Cleaning
— • [Enter] key: saves the setting and shifts to the sub menu.
• [Cancel] key: shifts to the previous menu.
5.1 Setup menu