MUTOH VJ-1624 - Replacing Roll Media

6 Maintenance VJ-1624 OPERATION MANUAL
6-8
• Insert the high capacity pack adapter all the way to the end of the slot.
6. Confirm that the operation panel returns to Normal.
NOTE
• If the high capacity pack adapter is replaced during a print job, the printer resumes printing.
• Replacing the high capacity pack adapter is complete.
CAUTION
After installing the high capacity pack adapter, make sure to perform initial ink
charge from the Cleaning menu in the following case.
• When using the high capacity pack adapter for the printer whose ink is charged
for the first time
• When the high capacity pack adapter has been used, and after replacing it with
a new one and installing it to the printer
If you use the high capacity pack adapter without performing initial ink charge, the
air inside the high capacity pack adapter goes into the printer ink tube and may
cause nozzle clogging.
5.3 Cleaning menu
6.1.2 Replacing Roll Media
This section describes when and how to replace the roll media.
(1) Replacement time
Replace the roll media when the following situation occurs.
a. When the roll media loaded in the printer runs out
• "End Of Roll" is displayed on the operation panel.
• If media runs out during printing, the printer stops printing.
b. When you want to change the media type to use
(2) Type
TIP
• For types and details of the roll media, refer to "8.3 Options/Supply list".