7 Troubleshooting VJ-1624 OPERATION MANUAL
7-12
NOTE
• [****] of the error display indicates the ink color that is subject to warning.
7.2.3 Error requiring restart
This section describes errors requiring restart and remedies.
An error requiring restart is displayed if a fatal operational failure such as the following occurs.
• When an obstacle that prevents printing occurs
• When a problem occurs with the electrical circuit (PCB, motor, sensor, etc.) of the printer
• When a failure in the printer control program occurs
If an error requiring restart occurs, the printer stops operating after performing the following operations.
1. The drive power automatically shuts down.
2. All lamps on the operation panel blink, and the buzzer rings continuously.
3. The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring restart, operation will return to normal after removing the cause of the error and
restarting the printer.
If the same error continues to be displayed, contact the your local MUTOH dealer.
Be sure to tell us the code no. of the error message when you contact us.
36 Measurement Error
(White Calibration)
White calibration has failed. • Open the maintenance
cover on the left side of the
printer and install the white
reference plate correctly.
• When the white reference
plate is contaminated,
apply a damp and tightly
squeezed soft cloth to clean
it.
• Start printing and
measuring the color target
again.
• If you still have trouble,
contact your local MUTOH
dealer.
4.5 Using
spectrophotometer
(SPECTROVUE
VM-10)
37 Measurement Error
(Iligal Operation)
Colorimeter has been
installed forcibly without
following the proper color
measurement procedure.
Remove the colorimeter.
4.5 Using
spectrophotometer
(SPECTROVUE
VM-10)
No. Display Description Remedy Reference
To Next Page
Loading...
Need help?
General