3 Before using VJ-1624 OPERATION MANUAL
3-18
• When an ink cartridge is installed, "Ink Refill **%" is displayed on the operation panel and ink
replenishment starts.
• Initial filling takes about six minutes.
Ink filling operation and pause operation are repeated during the ink replenishment.
• When "100%" is displayed, the ink replenishment is complete.
CAUTION
• Do not perform the following operations during ink filling. If filling is interrupted,
ink will be lost when filling is resumed.
• Do not turn OFF the power of the printer.
• Do not unplug the power cable of the printer.
• Do not open the front cover.
• Do not open the maintenance cover.
• Do not raise the media loading lever.
• When the initial ink charge is complete, "SubTank Refill **%" is displayed on the operation
panel, and the printer starts filling the subtank.
• When "100%" is displayed, the subtank ink replenishment is complete.
NOTE
• If the printer perform the nozzle check printing immediately after initial ink replenishment is
complete, the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow "6.2.3 Head cleaning" and refill a small amount of ink. Then, check the
printing result.
If there is no improvement in the print result even after refill a small amount of ink, leave the
printer unused for an hour or more. Then, refill a small amount of ink again and check the print
result.
If there is still no improvement, contact your local MUTOH dealer.
3.3.3 Installing high capacity pack adapters (option)
Use the optional high capacity pack adapters to use the 1000ml ink packs on this printer.
Follow the procedure below to install the high capacity pack adapters.
1. Check the angle of the ink cartridge slot to see if the insertion angle of the ink cartridge is horizontal.
To Next Page
Loading...
Need help?
General