4 Handling the printer VJ-1624 OPERATION MANUAL
4-22
• The printer operates as follows.
NOTE
• If a large amount of data is saved on the printer, the operation panel may not return to Normal
by a single [Cancel] key operation.
In such cases, wait for a few seconds and press the [Cancel] key again.
4.4.3 Cutting media
This section explains how to cut media.
If Media ejection mode is set to "Cut", the printer cuts the media automatically after printing.
5.1.6 Output Mode menu
If you press the [Cutting] key on the operation panel more than two seconds while the operation panel is
Normal, you can cut the media at the desired position.
Follow the procedure below to cut the roll media.
1. Confirm that the operation panel is Normal.
2. Press the [Cutting] key on the operation panel for more than two seconds.
Printer status Operation with the [Cancel] key pressed for two seconds
During printing Terminates the printing, and deletes one data remaining in the printer.
Receiving data/analyzing data Deletes the data already received and converted.
To Next Page
Loading...
Need help?
General