Chapter 5 Understanding the Remote Set tool 59
ICS Remote Tools User Guide
Remote Set tool command buttons
You can perform the following functions with the three buttons found at the top of the
Remote Set tools screen.
Using the keyboard
When you program the ICS using the simulated telephone, you can use the computer keyboard to
enter information. Keyboard entry is usually faster than using the mouse to click the simulated
telephone buttons in the window, and is more like using a real telephone.
Pressing F1 on the keyboard displays a list of the keyboard entry mappings, which are listed in the
following table.
Following are some of the rules around using the keyboard when the Remote Set tool is active.
Refer to
Figure 28.
• All letters, all numbers including those on the numeric keypad on your computer, some or all
function buttons, and the symbols * and # are recognized and translated to the equivalent
button presses on the simulated telephone appearing in the window after you enter the
programming session.
• Keyboard entry keys are not case-sensitive. No distinction is made between upper and lower
case.
• The keyboard F keys are mapped to program sequences or keys that do not have a direct
keyboard equivalent. For instance, pressing F7, which is the equivalent of Feature **266344
(CONFIG) starts the configuration programming. F6, which is the equivalent of the Release
key, exists the programming session.
• When entering telephone and line names, letter buttons on the keyboard are interpreted as
numbers. On the telephone keypad, notice that the 2 button, for example, lists the letters A, B,
and C above it, and that all the number buttons except 0 have letters listed above them.
Pressing A on the keyboard is interpreted as a 2. Pressing B is interpreted as two 2s. Pressing
C is interpreted as three 2s, and so on.
• Use number buttons for entering sequences such as **266344 (CONFIG).
Table 3 Remote Set tool command buttons
Button label Description of function
M7310 or M7324 To change the screen from one telephone simulation to another, click
the M7310/M7324 button that appears at the top, left of the Remote
Set screen. The button displays the telephone model that is not
currently displayed.
Change Password You can use the Remote Set screen to change the password for the
RAD you are connected to.
WARNING: Make a note of the password in a secure location. If you
lose the password, the RAD cannot be reactivated.
Exit Use to close the window and return to the Customer Info screen.
To Next Page
Loading...
