Ensure the best quality output 137
Methods to optimize the output quality
Optimize the output quality on the printer
Introduction
This section describes different methods which you can use to optimize the
output quality on the printer under the conditions described in the previous
section.
Problem analysis and solutions
[28] Problem anal ysis and soluti ons
Problem Method of
analysis
Solutions
The color of one
area merges with
the color of an-
other area
Quality check
print
■ Use the 'Area fills' content mode (see
‘Output quality and print speed’ on
page 123)
■ The media type defined on the printer
must be the same as the media
available on the printer. If the media
type defined on the printer is not the
same as the media available on the
printer, use the 'Change media type'
wizard to change the media type (see
‘Change the type of media defined on
the printer’ on page 164)
■ Use coated media
■ Use the default drying time
■ Use the setting KO - Printer -
Climate dependent alignment to
define if the system must
automatically do an alignment when a
large change in climate occurs.
■ Remove the printer from high
humidity conditions.
To Next Page
Loading...
