Oce TCS400 - Start the Applications with Océ Remote Logic

256 Océ TCS400 User manual
Start the applications with Océ Remote Logic®
Introduction
Use the following two methods to start the applications with Océ Remote
Logic
®
.
■ Use the programs menu of your operating system.
■ Use a command line parameter.
Use the programs menu to start the applications
1
Select 'Océ Remote Logic'
2 Select the 'Launcher' application.
3 Select the required application.
The application starts with your default system.
Note: You can select another system than your default system (see ‘Connect to
the controller’ on page 260).