Oce TCS400 - Use the Océ TCS400 Scanner to Perform Copy Jobs; Define the Copy Settings on the Scanner Operator Panel

Make copy jobs on the Océ TCS400 61
Use the Océ TCS400 scanner to perform
copy jobs
Define the copy settings on the scanner operator panel
Introduction
This section gives a description of the setting cards and describes how to
change the default settings for the copy jobs.
The copy settings
The copy settings are divided over the following four setting cards on the
scanner operator panel:
1 The 'Original' card.
2 The 'Output' card.
3 The 'Layout' card
4 The 'Image' card.
[20] The Origin al card
[20] The Original card
[21] The Output card
[21] The Output card