44 Océ TCS400 User manual
Energy save modes
Introduction
The Océ TCS400 has two modes to prevent unnecessary power consumption.
■ The energy save mode
The energy save mode functions only for the printer and Océ Power Logic
®
controller.
■ The sleep mode.
The energy save mode
The system uses less energy in the energy save mode than in the normal
operating mode. Both the printer and the Océ Power Logic
®
controller remain
turned on. By default, the energy save mode is enabled in the Océ Settings
Editor. Use the setting KO - System - Timers - Energy save mode in the Océ
Settings Editor to define the delay in minutes before the Océ TCS400 enters
the energy save mode.
When the Océ TCS400 is in the energy save mode, you can activate the system
as follows:
■ Send a job
■ Press a key on the printer operator panel
■ Press the retract button to retract a roll
■ Load a roll.
Note: The energy save mode complies with the EPA Energy Star
®
sleep mode
requirements for wide format printers. In Appendix B this mode is referred to
as sleep mode.
The sleep mode
The power supply of the printer is turned off in the sleep mode. The exposure
lamp on the scanner turns off and the screen displays a sleep mode message.
The Océ Power Logic
®
controller remains turned on.
The system uses less energy in the sleep mode than in the energy save mode.
Use the setting KO - System - Timers - Sleep mode timer in the Océ Settings
Editor to define the delay in minutes before the Océ TCS400 enters the sleep
mode.
To Next Page
Loading...
