Oce TCS400 - Page 43

Getting started 43
Turn the Océ Power Logic® controller and the printer off
Perform the following when the setting KO - System - Synchronize printer
and Power Logic controller power on/off if the Océ Settings Editor is set to
'On': There are two possibilities:
1 Press the on/off button on the printer or
2 select 'Shut down' from the 'System' menu in the Océ System Control Panel.
The Océ Power Logic
®
controller and the printer both shut down.
Perform the following when the setting KO - System - Synchronize printer
and Power Logic controller power on/off if the Océ Settings Editor is set to
'Off'.
1 Press the on/off button on the printer.
The printer shuts down.
2 Open the Océ System Control Panel application on the Océ Power Logic
®
controller.
3 From the 'System' menu, select 'Shut down'.
The Océ Power Logic
®
controller shuts down.
Turn the scanner on and off
1
Press the switch at the rear of the scanner.
The scanner begins initializing.
2 After the scanner initializes, this takes 3 to 5 minutes, turn the Océ Power
Logic
®
controller on.
The scanner needs 5 minutes to warm up before you can scan a job. The
scanner needs 60 minutes to warm up for the best quality output.