Oce TCS400 - Connect to the Controller

260 Océ TCS400 User manual
Connect to the controller
Introduction
After you start one of the Océ Remote Logic
®
applications, you must connect
to the Océ Power Logic
®
controller of the Océ TCS400. You must connect to
the system for every separate application.
You can perform the following when you connect to the controller:
■ Select a system from the drop-down list.
■ Add a system to the drop-down list.
■ Remove a system from the drop-down list.
If the Océ TCS400 is not available in the 'Connect to' dialog box, you must add
the Océ TCS400 to the list of available systems.
How to connect to a system
1
Open the application you want to run.
2 From the 'File' menu, select 'Connect to'.
3 Select the system from the drop-down list.
4 Click 'OK'.
Note: From the 'File' menu, select 'Options' to define the default system. This
is recommended if you frequently connect to the same system.
How to add a system
1
From the 'File' menu, select 'Connect to'.
2 Click 'Edit'.
The 'Edit systems' dialog box appears.
3 Enter the IP address or the name of the system in the 'Systems' box.
4 Click 'Add'.
The system is added to the list.
5 Click 'OK' two times to return to the application.