Make copy jobs on the Océ TCS400 73
Define the position of the image on the output
Introduction
Define the position of the image on the output in the 'Layout' card of the
scanner operator panel.
Before you begin
The system calculates the position of the image on the output based on the
media width selected on the 'Output' card. Before you define the position of the
image on the output, first define the media width on the 'Output' card.
When you select 'Automatic' as the 'Media width', the system puts the image
on the output based on the width detected by the scanner.
When you select 'Roll width' as the 'Media width', the system puts the image
on the output based on the width of the selected media roll.
When you select a standard size as the 'Media width', the system puts the image
on the output based on the selected standard size.
(see ‘Define the output settings’ on page 70)
To Next Page
Loading...
