Scan to file on the Océ TCS400 85
Important scan-to-file settings
Define the size of the originals
Introduction
The following settings are available:
■ 'Automatic'
The scanner detects the size of the original based on the width of the
original.
This is the recommended setting.
■ 'Standard width'
The scanner scans only the selected standard width.
This setting overrules the automatically detected width of the original.
■ 'Custom'
The width is the width selected in the 'Original custom width' setting and
the length is equal to the length selected in the 'Original custom length'
setting.
Before you begin
Use the KO - System - Media - Paper series setting in the Océ Settings Editor
to define the default paper range used when you select 'Standard' as the '
Original size method'.
Define the original size
1
Select the 'Original' card with the upper softkeys.
2 Select the 'Original size method' setting with the softkey for 'Size'.
3 When you select 'Standard width' as the 'Original size method', use the softkey
for 'Standard' to select the original standard size for the defined paper range.
4 If you select 'Custom' as the 'Original size method', use the softkey for 'Custom'
to select 'Custom width' or 'Custom length'.
5 Use the arrow keys to define the 'Custom length' and the 'Custom width'.
If you select 'Full length' as the 'Custom length', the complete length of the
original is scanned.
To Next Page
Loading...
