174 Océ TCS400 User manual
Define the correct media for your jobs
To achieve optimal output quality.
1 Make sure you load and define the correct media type on the printer.
Use the 'Change media type' wizard to load a media roll and to change the
media type defined on the system.
2 Make sure you define the correct media type for your job. Make sure the media
type and the media format defined in your job is available on the printer.
Define the correct media on the printer and the correct settings in the job
submission tools to set the Océ TCS400 for productive use or high output
quality.
When productivity with different media sizes is the most important
requirement
1 Load and define two media rolls on the printer with different media sizes and
the same media types.
2 Use the 'Landscape' orientation to print a job on a media size that is one size
smaller than the media defined on the system. For example, 23x33 prints in
landscape on 33x47 and 17x23 prints in landscape on 23x33. You are not
required to cut the media by hand.
3 Use the 'Auto rotate' setting in the Océ Settings Editor or the job submission
tools to rotate the orientation automatically.
The above procedure is based on DIN media sizes. You can also use this
procedure with ANSI media sizes.
If productivity is the only important requirement
1 Load and define two media rolls on the printer with the same media sizes and
the same media types.
2 Enable the 'Automatic roll switch' in the Océ Settings Editor or the job
submission tools.
If roll one is empty, the printer switches automatically to roll two.
If the output quality is the most important requirement
1 Load and define two media rolls on the printer with the same media sizes and
with different media types.
Select the media types you define based on the output quality you require.
To Next Page
Loading...
