Oce TCS400 - Define the Output Settings

70 Océ TCS400 User manual
Define the output settings
Introduction
Define the output settings for your copy output in the 'Output' card of the
scanner operator panel.
You can define the following settings:
■ Media type
■ Media width
■ Cut length
■ Add strip.
Use this setting to add a strip to your output. A leading strip is added to the
top of your output. A trailing strip is added to the bottom of your output.
Before you begin
Use the KO - System - Media - Paper series setting in the Océ Settings Editor
to define the default paper range used in the 'Media size' setting.
Use the KO - Jobs - Copy - Template - Output card - Media setting in the
Océ Settings Editor to define a default media type for your jobs.
Define the media type
1
Select the 'Output' card with the upper softkeys.
2 Select the 'Media type' setting with the softkey for 'Media type'.
3 Use the softkey for 'Media type' to select the media types available on the
printer.
4 Use the spin box with the arrow keys to select a media type that is not available
on the printer.
If you select a media type that is not available on the printer, the Océ System
Control Panel and the printer operator panel display a media request.